Remote Access - PIX 7.2(3) Issue

[ciscows]

Hi,

The tunnel connects and I am able to grab an IP address from the correct range. However, I am not able to pass traffic between the tunnel (192.168.5.0) and the DMZ interface/network (192.168.4.0).

What piece or pieces am I missing from my configuration?

I have attached the config.

thank you,

G

[aghaznavi]

Please check your ACL it might be correction required.

[acomiskey]

dmz nat exemption acl should be

access-list NamPix_DVC_nat0_outbound extended permit 192.168.4.0 255.255.255.0 192.168.5.0 255.255.255.0

Also, I don't think you need this route...

no route NamPix_DVC 192.168.5.0 255.255.255.0 192.168.4.1 1

You also have no group policy cdcvid defined.