Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Remote Access - PIX 7.2(3) Issue

Hi,

The tunnel connects and I am able to grab an IP address from the correct range. However, I am not able to pass traffic between the tunnel (192.168.5.0) and the DMZ interface/network (192.168.4.0).

What piece or pieces am I missing from my configuration?

I have attached the config.

thank you,

G

2 REPLIES
Silver

Re: Remote Access - PIX 7.2(3) Issue

Please check your ACL it might be correction required.

Green

Re: Remote Access - PIX 7.2(3) Issue

dmz nat exemption acl should be

access-list NamPix_DVC_nat0_outbound extended permit 192.168.4.0 255.255.255.0 192.168.5.0 255.255.255.0

Also, I don't think you need this route...

no route NamPix_DVC 192.168.5.0 255.255.255.0 192.168.4.1 1

You also have no group policy cdcvid defined.

103
Views
0
Helpful
2
Replies