Use a DB9 to DB9 null modem cable. Sometimes the Cisco Secure PIX Firewall will ship with two DB9 to RJ-45 adapters. If you have these adapters, connect one to the Cisco Secure PIX Firewall, and the other to your PC's serial port. Use a rollover cable (not a crossover cable) to connect between the two RJ-45 adapters. Set your HyperTerminal settings to N81, no flow control, 9600 baud. If you are still having trouble, check your PC COM port configuration and verify it is setup and working properly. If you're confident everything else is setup properly, test it on a router or switch and see if you get a prompt there. For more information, go to the PIX documentation for your PIX software version. From that page, select Installation Guide, and then select Installing Interface Cables for detailed diagrams and instructions.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...