Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

remote access vpn config problem on 506E

Hi,

Remote access vpn configuration is done on the pix 506E. I am got the ip address 172.16.1.1 the pool defined in the configuration, the gateway showing as 172.16.1.1..I cannot able to telnet and access anything inside. I am attaching the config.Please help me to resolve the same, this is very urgent.

Thanks in advance,

Regards,

Ram

5 REPLIES
Gold

Re: remote access vpn config problem on 506E

apply the command "isakmp nat-traversal 20"

New Member

Re: remote access vpn config problem on 506E

Hi,

Thanks for the update. Please let me know any config error was there. Now we are facing another problem, mails are not accessable from the outside through web.Please help me to resolve the same.

Regards,

Ram

New Member

Re: remote access vpn config problem on 506E

Hi,

I still facing a probelm. I cannot able to do the telnet from inside after coming to the inside with the pool.Please help me to resolve the same.

This very urgent. Please help me.

regards,

Ram

Gold

Re: remote access vpn config problem on 506E

On your 506, in config mode do: management-access inside, now you'll need to allow telnet access for your ip pool, i.e.

In config mode: telnet 172.x.x.0 255.255.255.0 inside

Now if you connect you using your vpn clinet to the pix, you should be able to ping the inside interface of the pix plus also telnet to the pix on the inside interface.

PS. Also add: isakmp nat-traversal (in config mode) and save all with: write mem

Hope this helps,

Jay

New Member

Re: remote access vpn config problem on 506E

Hi,

Thanks alot for your help. It is perfectly working fine.

Regards,

Ram

99
Views
5
Helpful
5
Replies
CreatePlease login to create content