I have a Linux server doing DHCP. It has two net cards in it. One is assigned a valid IP and one is private. I have a Cisco 1700 series on the public side connected to a T1 with a public. I can ping the Linux ethernet card from home but cannot get a tunnel setup. I have a few workers that need access from home. Home users do not have static IPs. How do I configure the router to allow PPTP? Please be kind I am novice.
I will need remote access into the server for management. I have a user that will need to access some files in a PC. I really do not have any apps per say. The Linux server is running the VPN. The sh ver gave me.......c1700 software (c1700-03sys6I-M), version 12.1(21), release (fc1). For instance my remote sits on a comcast cable modem, I have 24.28.40.x, which I am sure is NATed. Do I do a whois on my IP and find the valid IP segment on Comcasts network and set up an ACL on that. Thanks in advance.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...