cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
255
Views
5
Helpful
2
Replies

Remote VPN users need to connect to existing site-to-site tunnel

SlavaGirshman
Level 1
Level 1

I have two sites:

Site A (ASA5510)

Site B (PIX506E)

There is a working ipsec site-to-site tunnel between Site A and Site B.

I just setup a new config on Site A for remote users. Remote VPN users are able to connect to Site A and access all resources locally.

However they cannot access any resources at Site B. Is this something that's even possible?

The remote users get IPs from remote vpn IP pool, while site-to-site tunnel is setup to protect only the existing internal intefaces. I did not find any place in the ASA to create routes from the remote vpn ip pool to the existing site-to-site tunnel.

Any help with this would be greatly appriciated.

2 Replies 2

jmia
Level 7
Level 7

Hi,

Take a look here...

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f307.shtml

Hope this helps let me know if you need any further help/explanation. And please rate post if it helps!

Thank you very much! This is exactly what I was looking for. I now have remote vpn clients that have full access to both sites!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: