Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Removal of static, conduit, and route commands

I can't seem to find this in the docs anywhere - how does one remove static, conduit, and route commands on a Pix 515, v5.3? Can one simply type the word 'no', followed by the command?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Removal of static, conduit, and route commands

Hi,

one can simply type 'no' followed by the command. But you have to be in config mode to do this.

Kind Regards,

Tom

1 REPLY

Re: Removal of static, conduit, and route commands

Hi,

one can simply type 'no' followed by the command. But you have to be in config mode to do this.

Kind Regards,

Tom

177
Views
0
Helpful
1
Replies
CreatePlease to create content