We setup the PDM GUI for our PIX quite a while ago and can't remember the the second password needed to get into the configuration tool. Is there a way from the command line interface to see what the username might be or a way to reset it so that we can use the GUI interface again? Any help would be appreciated. TIA.
OK, I'm able to get in but now I'm running into another error that shows in the status bar of the browser: "exception: java.security.AccessControlException: access denied (java.util.PropertyPermission java.version read). This is happening after I login the first time to bring up the second browser that is supposed(?) to bring up the config util. Any suggestions? TIA.
What version of Java are you running? Some versions have issues with various Cisco GUIs. I run 1.4.2_05 and it works on all Cisco products. If you are running a different version, you might try finding this version and giving it a shot. Also, make sure you turn your popup blocker off.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...