Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Restore PIX config

I would like to upgrade my PIX520 software from 5.0.x to 6.1.x and my question is will the older 5.0.x configuration commands work fine with 6.1.x ,if I restore my old config .

1 REPLY
Cisco Employee

Re: Restore PIX config

Yes, from memory, all commands should work fine. Just make sure you keep a backup copy of your config etc, just in case thigns go wrong during upgrade.

http://www.cisco.com/warp/public/110/upgrade.shtml

Just a note;

You need a new activation key when you upgrade a PIX from a restricted software bundle to a bundle which supports additional features, such as more connections, failover, IPSec, or additional interfaces. Also, a new activation key is necessary after a flash upgrade on a PIX.

HTH

R/Yusuf

93
Views
0
Helpful
1
Replies