Re: restricting traffic from 1 router to 2nd by config acc-list
More than likely this can be done with access lists but they may be a little complex in a fully meshed network. You are probably better off looking at a firewall solution and then you can be very specific about what traffic to allow. Talk it over with your technical support people.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...