Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

reverse NAT

Is it possible to NAT multiple hosts in one DMZ to inside ? kind of a reverse way and PATing on the inside...

Any idea ? TIA

2 REPLIES

Re: reverse NAT

Hi try this commands:

nat (dmz) 1 0.0.0.0 0.0.0.0 outside

global (inside) 1 interface

Maje sure you allow traffic from dmz with an access-list

access-list dmz_in permit ip any any

acces-group dmz_in in interface dmz

I hope it helps ... please rate it if it does !!!

New Member

Re: reverse NAT

Thanks. btw, the requirements has been changed there will be 2 source hosts ex 10.20.1.11 & 12 fr DMZ and only one destination host in inside 10.16.1.23 the rule is only 11 & 12 will initiate the traffic not fr inside or i should say fr less secure to more secure kind of bi-directional nat.

Any suggestion ?

148
Views
0
Helpful
2
Replies
CreatePlease to create content