RIP UPDATE THRU VPN

[cfajardo1_2]

SCENARIO

-2X 3800 ROUTERS

-LEASE LINE CONNECTION

ACTION DONE

-IPSEC CONFIG BET 2 ROUTERS

GOOD OBSERVATIONS

-Encryption was taking place between wan interfaces.

BAD OBSERVATIONS

-lan reachability is not taking place

-RIP UPdate is not happening after VPN config. Route bet LANs are not shown on the routing table. Without the VPN, route thru RIP is on the table.

What is the solution to have this routing table with or without vpn.

Thanks

[ajagadee]

One solution is to configure GRE Over IPSEC and pass RIP Updates. Please refer the below URL for details. Even though the URL discusses about EIGRP, you could apply the same concept to RIP as well.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080093f85.shtml

Regards,

Arul