it started working after i manually deleted like 2 gigs of logs. from what i was told there was a flaw in CSPM 2.3.1(i) that filtered events were not always filtered. well i have high amounts of traffic by this sensor and the logs filled up the whole partition to like 7 gig. this is when the command started flaking out. after about 2 gigs of files got deleted it started working properly.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...