Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

route between protected ports

Hey all, I'm trying to get two port-protected ports on a 2900xl to talk to each other via the 2514 e0 port that the switch is attached to. SO far I've tried proxy-arp and static routes but I still can't ping across it. Has anyone done this? I seem to be trying to do exactly what was intended by this feature but I can't get it to work.

Thanks

3 REPLIES

Re: route between protected ports

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Community Member

Re: route between protected ports

Yes by all means respond. I don't think this is too complex or rare for this group at all! Please toss me a bone!

Community Member

Re: route between protected ports

Nevermind I figured it out myself. I guess the question WAS too hard for the folks on this list.

225
Views
0
Helpful
3
Replies
CreatePlease to create content