Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Route on PIX 7.0 based on source address

i have 2 hosts inside my network that each need to communicate with a remote network. there are two ways to get to the remote network and each host needs to take a unique path.

Ie, inside the DMZ there is RouterA which leads to 192.168.168.1 and RouterB leads to 192.168.168.1. Inside my PIX there is Host1 and Host2. Host1 needs to go through RouterA and Host2 needs to go through RouterB.

Like this:

host1---\ /---routerA

inside---PIX---DMZ

host2---/ \---routerB

I need to be able to tell the PIX

192.168.168.1/32 => RouterA

ACL 1 host2 IP

Route-Map

match acl 1

set next-hop = RouterB

or someother way to tell the PIX, if source-ip = Host2 the route to 192.168.168.1 = RouterB

Anyone have any ideas?

1 REPLY
Silver

Re: Route on PIX 7.0 based on source address

How about configuring a default route on Host1 to Router A and Host 2 to Router B ? Any downsides to this ?

222
Views
0
Helpful
1
Replies