Hi, I have a PIX 515E with version 7.x. It has two different internet links connected, one is used to get access to Internet from inside and the other I would like to use only for dynamical VPN clients.
How I have to configure this to make the VPN traffic, that comes from the second link go back for same interface? in actual configuration I have a default route pointing to first link.
I need use âsame-security-traffic permit intra-interfaceâ command to do this?
same-security-traffic permit intra-interface will not help in this case since the pix can only have 1 default gateway. You would have to know the source address of the vpn clients to be able to route to them from the second interface.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...