Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Routing between two IPSec tunnels

We have cisco 1841, i was able to establish 2 IPsec tunnels to 2 branch office, its working fine, both connecto main office OK, but can't connect to each other.

also i would like help to add pptp or L2TP for remote users

attahed is show run

thanks

2 REPLIES
Silver

Re: Routing between two IPSec tunnels

Just add a profile for branch router(vise-versa in another branch also) which triggers the link (interesting traffic) inadditional to existing profile for central site and also add static route in central site router for route traffic between the branches.

New Member

Re: Routing between two IPSec tunnels

sorry if i didn't check earlier, but i was going through everything again.

i would apperciate if you explain what you mean by adding profile for the branch router, i did added static routes for the branch office in the central here is my revised config again.

thanks for your reply, i wish i get to the bottom of this soon

193
Views
0
Helpful
2
Replies
CreatePlease to create content