Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Routing problem in PIX

Hi I have 2 networks: 10.120.1.0 and 10.125.1.0. This basically is connected on the 2 interfaces of Router i.e 10.120.1.0 to fa0/0 and 10.125.1.0 on fa0/1. The firewall 10.120.1.60 is connected on 10.120.1.0 and i am able to access internet from this network but from 10.125.1.0 i am not able to access internet. I have also applied route inside command connecting 10.125.1.0 to 10.120.1.0 in PIX.

Pls. suggest

  • Other Security Subjects
1 REPLY
New Member

Re: Routing problem in PIX

Could you please post your config. I would like to see your nat, global, and route statements at the minimum. In the mean time ensure you have the following

route (inside) 10.125.1.0 255.255.255.0 10.120.1.0 <-- routers ip address

nat (inside) 1 0 0

global (outside) 1 interface <-- or outside global subnet

or

route (inside) 10.125.1.0 255.255.255.0 10.120.1.0 <-- routers ip address

nat (inside) 1 10.125.1.0 255.255.255.0

nat (inside) 1 10.120.1.0 255.255.255.0

global (outside) 1 interface <-- or outside global subnet

If this doesnt work or you already have it specified, post your config and we can take a close look.

Regards,

Jami

79
Views
0
Helpful
1
Replies
This widget could not be displayed.