Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

rsa key pix 8

After I reload the PIX 515 with version 8.0(4)31
I checked the rsa key, it's not there.
I generated my key "crypto key generate rsa modulus 1024" again
save it using "write mem" and then reload,
it disappear after reload. Is it the right behavior?


Thanks for any reply.

1 REPLY

Re: rsa key pix 8

Hi,

The  crypto config key is not seen if you issue show run  or show start if that is what you meant in your post, the key should still be there ,  the show crypto key command syntax  bellow should provide details of your configured crypto key and modulus size etc.., or is it your case that no output is seen when you issue  the command bellow?

#show crypto key mypubkey rsa

HTH

Regards

268
Views
4
Helpful
1
Replies
CreatePlease to create content