SAME IP address in Static and NAT(global) command.
IN, PIX firewall, Is it possible to use same ip address for
allowing outside traffic to DMZ region by using static command , and to use same IP address for the NAT ( and global ) for the traffic generating from teh DMZ region and going to outside region. Will they conflict ? If yes is there is any work around.
This problem has occured due to destination system access our network and also expects data from our network on only one IP address !! ( This has forced to the sutuation of using static and nat,global commands on same IP address. )
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...