Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Same subnet on both ends of VPN

I have a PIX 501 with 6.3 sw.

Several VPN's in place already.

Need to setup VPN to new site, problem is they use 192.168.1.x subnet, and so do I.

Is there a way to setup an alias on the PIX?

What about a 2nd NIC in my end point device?

Traffic will look like this:

Far end 192.168.1.45 --> VPN --> my PIX --> my end 192.168.1.76.

Any ideas?

  • Other Security Subjects
1 REPLY

Re: Same subnet on both ends of VPN

Take a look at this guide. It might help ?

Configuring Overlapping Networks:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a0080172786.html#wp1113571

sincerely

Patrick

164
Views
0
Helpful
1
Replies
This widget could not be displayed.