Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Sample PIX and Router connected to INternet

Dear ciscoer,

Any sample config PIX connected to the Internet with Router. The router using the IP legal and router's ethernet 0 using 192.168.0.xxx. PIX ethernet0 using 192.168.0.xxx and the PIX's ethernet1 192.168.1.xxx. Where should I NAT the IP legal from ISP.

LAN(192.168.1.xxx)

|

|

PIX Inside (192.168.1.xxx)

|

PIX Outside (192.168.0.xxx)

|

|

Router Ethernet 0 (192.168.0.xxx)

|

Router Serial 0 (202.xxx.xxx.xxx)

Thank YOu In Advance

HATO

1 REPLY
Cisco Employee

Re: Sample PIX and Router connected to INternet

Hi Hato,

You could do NAT 0 on the pix and have the edge router do the NATing for you. This would be the simplest way to get it working.

Other option is to configure PPPoE. Below link is the FAQ for the PIX configuration.

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/prod_configuration_examples_list.html

Thanks,

yatin

100
Views
0
Helpful
1
Replies