10-24-2011 09:10 AM - edited 02-21-2020 04:29 AM
Hi all, I have this issue, I save the configuration in the ASA 5505 using write memory or using copy run start but whe i unplug the power cord and plug it back in the ASA gets its factory default configuration.... then what i do is a copy start run to get the configuration active....
why is this so? even though i saved the config to flash ... regards!
Solved! Go to Solution.
10-28-2011 01:49 AM
You have incorrect boot register:
Please follow up the following document:
http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1062992
You need to set up default value 0x1
___
HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer"
10-28-2011 01:49 AM
You have incorrect boot register:
Please follow up the following document:
http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1062992
You need to set up default value 0x1
___
HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer"
10-28-2011 07:07 AM
I never changed the config register. the default value was 0x41 . I switched it back to 0x1.
Thanks for your response!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: