Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Script Notification Support

Does CSPM support the use of perl scripts for notifications? If so, how? I have wrtten a script and specified the full path under the configure notifications menu. But I keep getting the following error messages:

GW 10/30/02 14:33:31 Notifier: Script: Unable to run specified script.

GI 10/30/02 14:33:31 Notifier: Script: notification.

GW 10/30/02 14:33:30 Notifier: Script: Unable to run specified script.

GI 10/30/02 14:33:30 Notifier: Script: notification.

Also, if cspm does not support perl script, what type does it support? Any help would be appreciated.

Thank you.


Re: Script Notification Support

I really dont know what the error message might mean. All the same here's some information and a checklist. To execute a script when specific network activities is detected by the sensors, the following tasks must be performed:

- Define notification rules based on the severity levels of attack signatures that you want scripts executed for

- Specify how often to execute the script

- Identify the path and name of the script to be executed


- Before CSPM can execute a script, you must place one or more scripts on the local CSPM server.

- Define the notification rules.

- Verify that the desired signatures are studied.

- Save configuration settings

Once these rules are taken care of, all should work fine.

CreatePlease to create content