Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SDM does not start

Hi All!

I have a 2621xm and want to test SDM. It was not pre-installed so I downloaded sdm22a.zip from Cisco. The setup-util cannot be used, because of a rpc-error. I believe that this has to do with a tighter behaviour of the more recent ios-versions. So I try to install SDM using tftp. I copied sdm.tar, home.tar and home.shtml. Then i point my browser to the routers interface. All looks ok but after some screens I receive the message that SDM was not found on the router. I tried version 22a and 11, results are the same.

Help? Thanks!

Henk

  • Other Security Subjects
1 REPLY
Silver

Re: SDM does not start

Take a look at this procedure and make sure you didn't miss any steps.

http://www.cisco.com/en/US/products/sw/secursw/ps5318/prod_installation_guide09186a00803e4727.html

Hope this helps

Steve

95
Views
0
Helpful
1
Replies
This widget could not be displayed.