I finally have access to a lab environment, where I have at my disposal 3 Cisco 2620XM routers.
Here's the scenario:
I have one router configured as shown below. I have my laptop, running Win 7 Premium 64 bit 8 Gb ram. It's running SDM 2.5. This version was able to partially connect to my virtual router in GNS3. It would connect, but would not do anything with VPNs...
So, I now have REAL equipment. So, I connected up to the router, and was able to configure it properly. Basically, F0/0 is the 192.168.1.0/24 network, and f0/1 is the 10.0.0.0/30 network. F0/0 has address of 192.168.1.1, F0/1 has 10.0.0.1. I have also configured a loopback as 192.168.1.2 . The config is listed below.
The problem I'm now having is SDM wont run! I can get it to start to load up just fine, but then it repeatedly says that SDM cannot connect to the device. It asks me to ensure the device is configured correctly. I've tried connecting to all three addresses. Please take a look at the config, and send me some thoughts on what I'm snarfing up. I've tried connecting with the box checked, and unchecked, for SSH.
version 12.3 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname R1 ! boot-start-marker boot-end-marker ! logging buffered 51200 warnings logging monitor informational ! memory-size iomem 10 no network-clock-participate slot 1 no network-clock-participate wic 0 aaa new-model ! ! aaa authentication login AAA_LIST_NAME local aaa session-id common ip subnet-zero ip cef ! username xxxxxx privilege 15 secret 5 $1$P1rJ$oVvrGIy3m.zjxFspdIP.B1 ! interface Loopback0 ip address 192.168.1.2 255.255.255.0 ! interface FastEthernet0/0 description Network 10.0.0.0/30 ip address 10.0.0.1 255.255.255.252 duplex auto speed auto ! interface FastEthernet0/1 description Network 192.168.1.0/24 no ip address shutdown duplex auto speed auto ! router eigrp 1 network 10.0.0.0 0.0.0.3 network 192.168.1.0 auto-summary ! ip http server ip http authentication local ip http secure-server ip http timeout-policy idle 600 life 86400 requests 10000 ip classless ! ! logging history size 300 logging history informational logging facility local6 ! ! line con 0 privilege level 15 logging synchronous login authentication AAA_LIST_NAME line aux 0 line vty 0 4 privilege level 15 login authentication AAA_LIST_NAME transport input telnet ssh line vty 5 15 privilege level 15 login authentication AAA_LIST_NAME ! ! end
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...