Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Securing config on 2610

Running ios 12.2 on cisco 2610. Observed unusual behavior whenever we experience power outage. Despite having saved running-config in NVRAM, after every power failure or router power-off, have to reconfigure. Is there anything we are missing out?

Thanks in advance.

Joe P.

2 REPLIES
New Member

Re: Securing config on 2610

Joe,

Check your config register. It is possible that the file is there but the router's "confreg" is setup such that it doesn't boot from nvram. Do a "sh ver" and check the last line. It should show "Configuration register is 0x2102".

If it's not then go to configure mode and type "config-register 0x2102" . Save your config and reboot the router.

New Member

Re: Securing config on 2610

Thanks for the reply. I did just that (since config register was showing oxA102). However when rebooting the rooter, trouble started! The following is the display I receive followed by a continous image decompression.

Thanks again.

Joe P.

== Flushing messages (02:00:37 Swazila Mon Mar 1 1993) ===

*** System received a SegV exception ***

signal= 0xb, code= 0x1200, context= 0x80f02ae8

PC = 0x803a4938, Vector = 0x1200, SP = 0x80fa7468

System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

Copyright (c) 1999 by cisco Systems, Inc.

TAC:Home:SW:IOS:Specials for info

C2600 platform with 24576 Kbytes of main memory

program load complete, entry point: 0x80008000, size: 0x5296c8

#######......

Smart Init is enabled

smart init is sizing iomem

ID MEMORY_REQ TYPE

000091 0X00092280 C2600 single Ethernet

00006F 0X00012580 Sixteen port A/D Modem

0X000F34A8 public buffer pools

0X00211000 public particle pools

TOTAL: 0X003A8CA8

If any of the above Memory Requirements are

"UNKNOWN", you may be using an unsupported

configuration or there is a software problem and

system operation may be compromised.

Rounded IOMEM up to: 4Mb.

Using 16 percent iomem. [4Mb/24Mb]

119
Views
0
Helpful
2
Replies