Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Securing subnets

I currently have a L2L session with a remote site. I only want them to have access to a certain range of hosts, not the entire subnet. How can I limit their access on the L2L?

1 REPLY
Cisco Employee

Re: Securing subnets

Hi Roger,

You can either setup your LAN to LAN tunnel to have access to only specific range of hosts and that way you wouldn;t need to do any filtering, but in case thats not an option then do the filtering on the Private filter by allowing the Remote Network to only have Permit rights to these specific hosts.

Hope this helps,

Aamir Waheed,

Cisco Systems, Inc.

-=-=-

104
Views
0
Helpful
1
Replies
CreatePlease to create content