Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Security monitor, manual blocking support for IDS 4.x

Security monitor, 1.2, does not permit iniation of a block from the event viewer. Pop-up states that currently only version 3 sensors are supported. Is manual blocking support planned for a future release? If so, when?

Thanks

3 REPLIES
Bronze

Re: Security monitor, manual blocking support for IDS 4.x

Hi, I was wondering if you tried blocking the signature from IDSMC instead? That would be equally effective.

New Member

Re: Security monitor, manual blocking support for IDS 4.x

Yes, I can configure blocking in the MC but also want to preserve the feature of blocking on the fly.

Cisco Employee

Re: Security monitor, manual blocking support for IDS 4.x

I know it has been discussed for possible inclusion in a future version, but I can't say whether or not it was agreed to of for which future version.

In the meantime, dropping on the fly has to be done through the IDM interface of the sensor.

77
Views
0
Helpful
3
Replies