Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Selectively allowing Active X and Java applet component through PIX

How do I configure PIX to allow Active X components from a trusted site and block Active X from all other sites? Is there any access-list type of command or outbound type of command that I could use to selectively allow Active X using PIX?

1 REPLY
New Member

Re: Selectively allowing Active X and Java applet component thro

use the filter command. you need to list each site you want to block like this -

pix1(config)# sh filter

filter java 80 0.0.0.0 0.0.0.0 10.1.1.1 255.255.255.255

filter java 80 0.0.0.0 0.0.0.0 20.2.2.2 255.255.255.255

filter activex 80 0.0.0.0 0.0.0.0 11.11.11.0 255.255.255.0

filter activex 80 0.0.0.0 0.0.0.0 99.99.11.0 255.255.255.0

221
Views
0
Helpful
1
Replies
CreatePlease to create content