Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Sending different Syslog message levels to different servers

Hi

I'm currently running a pair of PIX-515Es on 6.3(5). I'm looking to send syslog messages to different servers, say 1 and 2. What I want to do is send Level 7 (Debugging) and above to server 1 and Level 4 (Warnings) and above to server 2. At present I cant find any config that allows me to send different levels to different servers. Does anybody know or have any suggestions as to how I can do this?

Thanks in advance

Malcolm

3 REPLIES

Re: Sending different Syslog message levels to different servers

Hi

Can you try configuring different logging severity levels followed by the syslog server ip address ??

you can refer this link for more info selecting the severity levels either by the name or using the numbers and also the syntax invloved in configured the logging to an external host..

http://www.cisco.com/en/US/products/ps6120/products_system_message_guide_chapter09186a008055fd2a.html#wp1067582

regds

New Member

Re: Sending different Syslog message levels to different servers

Hi

The PIX doesnt give me the option to configure sysog messages on a host basis.

I think I could use the commands you've referenced if I was running version 7. Unfortunately however I'm running v6 which does support the predefined logging classes for syslog messges.

Best regards

Malcolm

New Member

Re: Sending different Syslog message levels to different servers

Sorry that should say 'doesn't suppport the predefined logging classes for syslog messages'

135
Views
0
Helpful
3
Replies
CreatePlease login to create content