1) We have a group of people that manage all network equipment and need full access to each of these devices.
2) We have another group that only needs user access to 2 of these network devices for doing 'show' commands.
I have been unable to setup the ACS so that it will allow Group 2, to ONLY access the 2 devices. I've tried putting NAR's in by user and it still doesn't work. It still allows them login access to ALL the network devices.
I've also tried setting Group 2 as a seperate group, also have tried putting the 2 network devices in a another Network Group.
Often times complex troubleshooting/configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...