Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setting Privilege levels in 6.2(2)

I would like to set certain privileges to different users in the PIX but when there is a telnet session to the PIX. When I set the username level to anything over 1, the user gets full access. Is there a way to set the privilege level to allow certain commands for a telnet session?

Thanks

1 REPLY
Cisco Employee

Re: Setting Privilege levels in 6.2(2)

You need to use the "privilege" command to assign certain commands to the certain privilege level, then that user can only do the commands assigned to his/her level.

See http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/mr.htm#1027446 for details.

100
Views
0
Helpful
1
Replies
CreatePlease login to create content