setting up a dsl as failover on 2600 series router
I need to setup a failover line. the primary line is a T1 which is connected to serial interface. the secondary line is install to the FE0/1 of a 2600 series router. when i configure the nat pool IPOOL i get a error message saying that dynamic maping in use i need to have a sample config to complete this
Re: setting up a dsl as failover on 2600 series router
the msg comes up in there at nat sessions moving on...so u need to clear the ip translations and try executing the command.. if still msg crops.then u might hv to shut the local inside nat interface for a while ..
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...