Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

setup routing in a ASA

I have a ASA 5520, how do I set up a static route to route traffic to a router, I have 10.9.1.0/16 on the ASA which my users are on, on the router I have 192.168.0.0/16, how do I set to ASA to route to the router for the 192.168.0.0 network?

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Blue

Re: setup routing in a ASA

Shane

Assuming 192.168.0.0/16 is on the inside of the ASA and the next hop from the ASA ie. the router is 192.168.0.1

route inside 192.168.0.0 255.255.0.0 192.168.0.1

Jon

Re: setup routing in a ASA

You've corrected enough of mine, so I'm just returning the favor! The only reason for the green star is that it's been a little slow so I've had more NetPro time.

6 REPLIES
Hall of Fame Super Blue

Re: setup routing in a ASA

Shane

Assuming 192.168.0.0/16 is on the inside of the ASA and the next hop from the ASA ie. the router is 192.168.0.1

route inside 192.168.0.0 255.255.0.0 192.168.0.1

Jon

Re: setup routing in a ASA

A slight modification to Jon's post-

The last IP in the configuration Jon posted is where the ASA should send packets to to get to the 192.168.0.0 network. It should be an address from 10.9.0.0 network.

Hall of Fame Super Blue

Re: setup routing in a ASA

Oops, thanks for correcting my mistake :-)

And belated congrats for the green star !

Re: setup routing in a ASA

You've corrected enough of mine, so I'm just returning the favor! The only reason for the green star is that it's been a little slow so I've had more NetPro time.

New Member

Re: setup routing in a ASA

So since the 192.168.0.0 is 255.255.254.0 and the ASA is 10.9.1.0 255.255.0.0 is this right

route inside 192.168.0.0 255.255.0.0 10.9.1.4

Hall of Fame Super Blue

Re: setup routing in a ASA

Shane

If 10.9.1.4 is the IP address of one of the router interfaces then yes that would work.

Jon

129
Views
5
Helpful
6
Replies