Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

show crypto returns old ip

We recently changed our IP address and made the corresponding changes in the PIX config. When I issue the SHOW CRYPTO ... command as follows the old IP shows up for local addr.:

pixfirewall# show crypto ipsec sa

interface: outside

Crypto map tag: test, local addr. 64.218.35.29

Where is this value obtained and how do I change it if possible?

Thanks,

Fred

2 REPLIES
Silver

Re: show crypto returns old ip

Run the command:

clear crypto ipsec sa

this will clear this existing sa and the crypto map will build the new sa (f configured properly, ofcourse :-))

Community Member

Re: show crypto returns old ip

Thanks. That cleared it and the response is now correct.

105
Views
0
Helpful
2
Replies
CreatePlease to create content