Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show DMVPN

Newbie question: how do I enable "show DMVPN". It appears from below that it needs to be "enabled". I am using a variety of IOS and they all don't appear to have the command. Thanks

show dmvpn

To display Dynamic Multipoint VPN (DMVPN) specific session information, use the show dmvpn command in privileged EXEC mode.

show dmvpn [peer [nbma | tunnel {ip-address}] | [network {ip-address} {mask}]] [vrf {vrf-name}] [interface {tunnel number}] [detail] [static] [debug-condition]

Command Default

This command is not enabled.

Command Modes

Privileged EXEC

Command History

Release Modification

12.4(9)T

This command was introduced.

2 REPLIES
New Member

Re: show DMVPN

what version of the IOS are you running

Hall of Fame Super Silver

Re: show DMVPN

Jeff also posted this question in the Network Infrastructure WAN Routing and Switching forum where it has been successfully resolved as a version (and code train) problem. For details see that thread in the WAN forum.

HTH

Rick

1128
Views
0
Helpful
2
Replies