02-15-2008 05:15 PM - edited 03-09-2019 08:07 PM
Newbie question: how do I enable "show DMVPN". It appears from below that it needs to be "enabled". I am using a variety of IOS and they all don't appear to have the command. Thanks
show dmvpn
To display Dynamic Multipoint VPN (DMVPN) specific session information, use the show dmvpn command in privileged EXEC mode.
show dmvpn [peer [nbma | tunnel {ip-address}] | [network {ip-address} {mask}]] [vrf {vrf-name}] [interface {tunnel number}] [detail] [static] [debug-condition]
Command Default
This command is not enabled.
Command Modes
Privileged EXEC
Command History
Release Modification
12.4(9)T
This command was introduced.
02-19-2008 07:10 AM
what version of the IOS are you running
02-19-2008 10:02 AM
Jeff also posted this question in the Network Infrastructure WAN Routing and Switching forum where it has been successfully resolved as a version (and code train) problem. For details see that thread in the WAN forum.
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: