Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SHUN command PIX 515e ver 7.1(2)

I've never used this command before, so I'm not sure if this is an appropriate use...but, I have a 515-e running 7.12 with internal clients trying to hit their old ip scheme of 10.25.x.x (havent' found the source of why/what on the machines are still pointing to these old addresses yet) I have setup an access rule to deny all IP from inside to outside (10.25.x.x), and it's blocking like crazy! I was wondering if the "shun" command could be used in this case (to block any requests to the 10.25.0.0/16), and if so, what is the correct syntax. Thanks for any/all replies!

1 REPLY
New Member

Re: SHUN command PIX 515e ver 7.1(2)

Hello

shun command will only work on source address

see this info on command use

http://www.cisco.com/en/US/products/ps6120/products_command_reference_chapter09186a00805fb9e9.html#wp1105052

Your only option is block with an ACL as you already did.

Hope this helps ...rate if it does !

Regards

189
Views
5
Helpful
1
Replies