Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Shunning Problems

I've got a problem with shunning on netranger director,when i shun the host on the sensor the sensor does not attempt to send information do the router,and the sensor it's got the right configuration under the device management options and i can telnet to the router manually.please help!!!!,also when i snoop traffic between the sensor and the router the is no communication unless if i telnet manually.

3 REPLIES
Cisco Employee

Re: Shunning Problems

Does the sensor shun properly when it detects an alarm?? If not, do you have managed enabled? If so, try a shun from the command line on the director (nrexec 10003 1 30 ShunHost x.x.x.x

Community Member

Re: Shunning Problems

i tried a couple of things and at last i had to do nrhup on the sensor and it started working,but i did try to do this before but it didn't work.i'm still trying to find out what was the problem.thanks for the advice i will keep you updated if i found anything......

Cisco Employee

Re: Shunning Problems

I have seen instances in the past, when you make changes on the Director and PUSH it to IDS, the services do not start properly, you have to go onto IDS and stop and re-start all the services manually (as you did).

R/Yusuf

103
Views
0
Helpful
3
Replies
CreatePlease to create content