11-11-2003 03:22 PM - edited 03-09-2019 05:29 AM
When tracking MSBlaster using snoop, it shows many internal source IP addresses going out to the internet. Do you know why Sig id 5365 is not shown on the events monitor or any type of reports? The sig id is enable.
Thanks,
Kim.
11-11-2003 08:18 PM
Assuminig you are using 4.x issue commands:
sensor(config)#service netw
sensor(config-NetworkAccess)#show settings
Look at the signature enabled on the sensor
11-12-2003 12:26 PM
Thank you for your reply.
We are using 3.x and the sig is enabled. Question is why VMS does not show what we see on the sensor?
11-12-2003 07:41 PM
Has it worked and then it isn't working? What sp/sig level are you at presently?
11-13-2003 12:27 PM
We are using S58. Is there a signature that we can custom or one that exists to show machines that are excessively sending SYN packets to every single subnet on the internet?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: