Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Simple 515 config

I have a 515 PIX with a DMZ interface that I need to configure as:

Inside and DMZ NAT/PAT access through outside - (I have this working)

Inside to DMZ access with NO translation - NOT working

restricted DMZ to Inside access - NOT working

I have had very little exposure to PIX equipment, so I'm a bit green.

Can someone help?

Thanks!

1 REPLY
Cisco Employee

Re: Simple 515 config

Here is a good link for your reference: http://www.cisco.com/warp/customer/707/28.html .

Remember the traffic flow on pix depends on security level. Higher security 100, ussually the inside, need nat and global statement to go to lower security (outside or DMZ). Lower security like outside (0) or DMZ (50) need static and access-list or conduit to go to higher security (inside).

Regards,

81
Views
0
Helpful
1
Replies
CreatePlease to create content