by the way, how can i configure a site to site (one site static ip and the other dynamic by the ISP) VPN configuration with the PDM2.1 ? If i enter the ip 0.0.0.0 for the remote site, it says that is is not allowed...
If you don't know the IP address of one of your IPSec peers, then you have to configure a dynamic crypto map on the PIX (or via PDM). You can't use 0.0.0.0 as the peer address, that won't work.
In the Tunnel Policy section, the Type is Dynamic, and make the Priority higher than what you used for the known IPSec peer config. the nunder IKE - Pre-shared Keys, add a key for 0.0.0.0, this will be used for any host that doesn't have a specific key for it's address.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...