I've connected my two asa 5505 using a cross over cable. One has the external ip of 10.10.10.1 and the other one is 10.10.10.2. Using this setup, how can the two routers know what networks are behind the other firewall?
Is the access-list l2l_list extended permit ip 192.168.1.0 255.255.255.0 192.168.100.0 255.255.255.0 ( and vice versa on the other side) enough information or do I need to specify anything else. I'm a bit confused at the moment.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...