Site to Site VPN and one end has a DHCP address from ISP.
I am using an ASA 5510 as the hub and an ASA 5505 at the remote site.
Can some direct me to an article that walks me through setting up a site to site VPN that the far end has a DHCP ip address. I am pretty sure this can be done but I forget the syntax to do it. Plus I figure this would be faster than me digging for it.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...