Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Site to Site VPN using PPPOE

I have configured a remote 1811 router using a PPPOE connection back to HQ. Previously, it had a split tunnel configuration but I have changed it to have all traffic including web traffic to go over the tunnel. The tunnel is up but I am seeing timeouts and some latency. I have not seen any examples of PPPOE without configuring NAT? I am wondering if I have set this up incorrectly. Attached is the configuration of the remote 1811. Thanks.

  • Other Security Subjects
1 REPLY
Bronze

Re: Site to Site VPN using PPPOE

Add the proper route map to bypass the NAT process on the router if VPN doesnt come up.

128
Views
0
Helpful
1
Replies
This widget could not be displayed.