02-14-2004 05:41 PM - edited 02-21-2020 01:02 PM
Hi
Is it possible to configured Site to Site VPN (Full Tunnel) between Cisco 831 & VPN Concentrator 3005?
Thanks
MD
02-14-2004 10:38 PM
Sure, just follow this sample config:
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009482e.shtml
02-15-2004 09:33 AM
I think sample config is for Spilt Tunnel. We do currently using split tunnel I was looking for sample config that shows how to tunnel all the traffic (full tunnel).
Thanks
MD
02-15-2004 03:25 PM
Just change the access-list on the router to:
access-list 101 permit ip 172.16.1.0 0.0.0.255 any
access-list 101 permit ip 172.16.20.0 0.0.0.255 any
access-list 101 permit ip 172.16.30.0 0.0.0.255 any
and in step 5 of the 3000 config, remove the network list from the Local Network section, and use an IP Address of 0.0.0.0 and a Mask of 255.255.255.255. The Remote Network stays the same.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: