Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNA trafiic trhough PIX firewall

Is there any way to allow native SNA traffic ( IEEE802.2 LAN) to pass through

a PIX firewall ?

If so, what is the PIX config ?

4 REPLIES
New Member

Re: SNA trafiic trhough PIX firewall

yes you can allow this by openning tow ports 2065 and 2067 tcp and udp.

New Member

Re: SNA trafiic trhough PIX firewall

conf pix

access-list acl_in permit tcp x.x.x.x x.x.x.x any eq 2065

access-list acl_in permit udp x.x.x.x x.x.x.x any eq 2065

access-list acl_in permit tcp x.x.x.x x.x.x.x any eq 2067

access-list acl_in permit udp x.x.x.x x.x.x.x any eq 2067

access-group acl_in in interface inside

New Member

Re: SNA trafiic trhough PIX firewall

I think you are referring to the DLSw traffic, once encapsulated in to TCP . But, what I need to do is, without any encapsulation, to pass the NATIVE SNA traffic on LAN through the firewall. I bilieve that there should be some kind of bridging. Any ideas ?

Bronze

Re: SNA trafiic trhough PIX firewall

I do not believe this is possible. The PIX is a router rather than a bridge.

116
Views
0
Helpful
4
Replies
CreatePlease to create content