Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP access from wan to pix

Hi,

I need monitoring my remote pix from internet way snmp, but the pix no response to snmpwalk:

FIREWALL(config)# --------- PACKET ---------

-- IP --

Source server snmp==> wan pix

ver = 0x4 hlen = 0x5 tos = 0x0 tlen = 0x46

id = 0x0 flags = 0x40 frag off=0x0

ttl = 0x29 proto=0x11 chksum = 0xd5ff

-- UDP --

source port = 0x9da1 dest port = 0xa1

len = 0x32 checksum = 0xa6bd

-- DATA --

00000010: 30 28 02 01 | 0(..

00000020: 00 04 09 72 34 6d 30 73 73 4e 57 62 a1 18 02 01 | ...community....

00000030: 00 02 01 00 02 01 00 30 0d 30 0b 06 07 2b 06 01 | .......0.0...+..

00000040: 02 01 01 02 05 00 1e | .......

--------- END OF PACKET ---------

debug packet outside proto udp dport 161 both

debug packet outside dst serversnmp both

Pix not send ack or traffic snmp.

Aditional i have vpn lan-2-lan i can see the ips in lan remote, but i can´t see the ip of interface inside of pix.

1 REPLY

Re: SNMP access from wan to pix

Hi,

I am not sure whether you have seen the following doc on SNMP guide for PIX:

http://www.cisco.com/en/US/customer/products/hw/vpndevc/ps2030/products_tech_note09186a0080094a13.shtml#snmptothepix

Look under 'Version 6.2 snmpwalk of PIX' for snmpwalk.

snmpwalk -c public

Another PIX SNMP guide link is:

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094469.shtml

Hope this helps.

Rgds,

AK

112
Views
0
Helpful
1
Replies
CreatePlease login to create content