cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
257
Views
0
Helpful
3
Replies

Snmp Traps don`t stopped at PIX

pslavkovsky
Level 1
Level 1

Hi,

I need to stop SNMP Traps on PIX (ver. 6.3(5)), Traps comes from outside to inside, it comes very often, every 5 seconds. I added row to access list on first place:

deny udp <source IP> <destination IP> eq snmptrap

But hitcount is only 29, and SNMP traps still comes to inside.

How is ti possible?

Thanks

3 Replies 3

froggy3132000
Level 3
Level 3

Can you post your config? Sounds like you have a translation built for this already.

Sorry, I can not post config.

But I do not use translation.

I use nat 0 access-list

and

sh xlate:

0 in use, 0 most used

Is it possible that PIX has connection created by first SNMP trap and I added row in ACL after this and now all SNMP traps go over this existing connection?

Now it is better, hitcount is about 5000, but still comes some this traps on inside, I see this traps on network Management console.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: